KKK-T--683F
allowed to cool slowly except where heat treatment is required. All modular
assembly fabrication shall provide for interchangeability of components.
3.10.4 Welding. The surfaces of parts to be welded shall be free from rust,
scale, paint, grease, and other foreign matter. Welds shall transmit stress
without permanent deformation or failure when the parts connected by the welds
are subjected to proof and service loading.
3.10.4.1 Qualifications for welders and welding equipment operators. The
contractor shall be responsible for qualifying all welders and welding equipment
operators in accordance with AWS B2.l using the contractor's or manufacturer's
recorded welding procedure. The Government may require the recertification of
any welder or welding operator.
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the contract,
the contractor is responsible for the performance of all inspection requirements
as specified herein. Except as otherwise specified in the contract, the
contractor may use his own or any other facilities suitable for the performance
of the inspection requirements specified herein, unless disapproved by the
Government. The Government reserves the right to perform any of the inspection
set forth in the specification where such inspections are deemed necessary to
assure supplies and services conform to prescribed requirements.
4.1.1 Component and material inspection. The contractor is responsible for
insuring that components and materials used are manufactured, examined, and
tested in accordance with referenced specifications and standards.
4.2 Classification of inspections. The inspection requirements specified
herein are classified as follows:
a.
First article inspection (see 4.3).
b.
Quality conformance inspection (see 4.4).
4.3
First article inspection.
4.3.1 Examination. The first article truck shall be examined for the defects
specified in 4.5.1. Presence of one or more defects shall be cause for
rejection.
4.3.2. Tests. The first article truck shall be tested as specified in
4.5.2.1 or 4.5.2.2, as applicable. Failure of any test shall be cause for
rejection.
4.4.
Quality conformance inspection.
4.4.1 Sampling. Sampling for examination and tests shall be in accordance with
ASQ Z1.4. The unit of product for this inspection shall be one fully assembled
truck. A lot shall consist of all trucks of one type offered for delivery at one
time.
4.4.2 Examination. Samples selected in accordance with 4.4.1 shall be for the
defects specified in 4.5.1. Inspection shall be level II with AQL of 1.0 percent
defective.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business