KKK-T--683F
4.5.2 Tests.
4.5.2.1 operational test, types I, III, and VI. Place load as specified in
3.5 on the applicable truck and allow truck to drop a distance of 2 inches over
the edge of a horizontal plane onto a concrete surface while in toward motion at
2 to 3 feet per second, with load in balanced position. Repeat test five times
and then examine truck for compliance with applicable requirement paragraph
specified. Nonconformance shall constitute failure of test.
4.5.2.2 operational test, types II and V. Place load as specified in 3.5 on
the applicable truck and allow truck to drop a distance of 2 inches over the
edge of a horizontal plane onto a concrete surface while in forward motion at 2
to 3 feet per second, with load in balanced position. Repeat test five times.
The loaded truck shall be tipped on it's side, using the rim of one wheel as a
fulcrum through an angle of 90 degrees, so that the axle is in a vertical
position and then return to an upright position. In addition, the type V truck
shall be loaded with 1,000 pounds equally distributed on the frame members for a
period of 5 minutes. After completion of all tests the truck shall be examined
for compliance with 3.5. Nonconformance shall constitute failure of this test.
5 PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be
as specified in the contract or order (see 6.2). When packaging of materiel is
to be performed by DoD or in-house contractor personnel, these personnel need to
contact the responsible packaging activity to ascertain packaging requirements.
Packaging requirements are maintained by the Inventory Control Point's packaging
activities within the Military Service or Defense Agency, or within the military
service's system commands. Packaging data retrieval is available from the
managing Military Department's or Defense Agency's automated packaging files,
CD-ROM products, or by contacting the responsible packaging activity.
6 NOTES
INFORMATION FOR GUIDANCE ONLY. This section contains information of a general
or explanatory nature that is helpful, but is not mandatory.
6.1 Intended use.
6.1.1 Type 1. The type I hand trucks are intended to be used to carry standard
55--gallon drums over short distances in warehouses and on paved surfaces.
6.1.2 Type II. The type II hand trucks are intended to be used for
transporting pressurized gas cylinders for medical or industrial use.
6.1.3 Type III. The type III hand trucks are intended to be used for handling
and positioning material within transporting aircraft, on transporter truck, at
support base railhead, on support base receiving dock, and on warehouse wood or
concrete floors.
6.1.4 Type V. The type V hand trucks are intended to be used for transporting
oxygen and acetylene cylinders, and welding accessories.
9
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business